メニュー

あなたの設定

注意：あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

ガイドに戻る
英語
日本語
次の手順

手順 1を翻訳中

手順1
Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.

  • Heat an iOpener and apply it to a long edge of the S8 for about 2 minutes.

  • You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.

  • As you're waiting for the adhesive to soften, move on and read the following step to get an idea of where to pry.

S8を縦長にした端に約2分間、温めたiOpenerを載せます。

デバイス本体が温まるまでiOpenerを数回温めて載せる作業を繰り返さなければなりません。加熱しすぎないために、iOpenerの温め方の説明に従ってください。

圧着剤が柔らかくなるのを待っている間に、次の手順に目を通して、どこから開口するかヒントを得てください。

[* icon_note] Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[* black] Apply a heated iOpener[guide|25705|Heat an iOpener|new_window=true] and apply it to a long edge of the S8 for about 2 minutes.
[* icon_note] Opening your phone will compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[* black] Apply a heated iOpener[guide|25705|Heat an iOpener|new_window=true] and apply it to a long edge of the S8 for about 2 minutes.
[* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.
[* icon_caution] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.
[* icon_note] As you're waiting for the adhesive to soften, move on and read the following step to get an idea of where to pry.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。