メインコンテンツにスキップ

Microsoft Corporationによって製造されたXboxワイヤレスコントローラー7MN-0001は、PCでも使用できるXboxゲームコンソールに最もよく使用されるコントローラーです。

127回答 すべてを表示

Stick drift persists after adjusting the sticks

Hey guys! I've been having bad upwards stickdrift on my right stick, so I took it apart and adjusted it to nearly completely remove it. It was fine. A bit of tiny downwards drift, but barely noticeable. Not long after, the drift has returned. I going to have to rip it apart and asjust sever times a day, or am I just doing it wrong?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
2 件のコメント

Which model is it?

さんによる

Sorry, I should have specified. 1708. The white one.

さんによる

コメントを追加

3件の回答

最も参考になった回答

You can try cleaning the stick with 99.5% isopropyl alcohol, this has helped me with the same issue in the past, just dab it in with a Q-tip, and clean.

このアンサーは役に立ちましたか?

スコア 1

5 件のコメント:

That was the first thing I tried. Before I tore it completely apart to adjust it.

I'm also getting double inputs on YouTube and Xbox dashboard of that helps.

さんによる

Hm. Hard to tell, with the double inputs, did you by chance get the controller wet? or spill anything on it?

さんによる

No, not that I know of. The double inputs seem to be linked to the control stick though. Whenever I adjust it to remove the drift, the double inputs go away, but they return as soon as the drift does

さんによる

Could it be the sensor that I've been adjusting? If I put a new one in there, might it work normally?

さんによる

A new sensor might fix the issue, however, be careful with the soldering. If there is damage to the logic board of the controller, it will persist.

さんによる

コメントを追加

The way plenty of people fix stick drift (including myself) includes the following.

  • Cotton Bud
  • Rubbing Alcohol
  • Controller
  • Wet the cotton bud w/ the RA then tighten it up/ squeeze the end, reapply RA then rub it all around the joystick as hard as possible

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

what the heck is a RA?

さんによる

コメントを追加

I just fixed this on my elite controller and the way i fixed it was by separating the up and down green piece a little. Hard to explain but after you get your controller apart there are 2 green pieces. One for up and down the other for left and right. My conclusions is that the piece is worn out so it's loose. Separate the green piece on the right just a little bit so the black prong on the side go in a little. This worked for me and nobody told me about it

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

Can you use the lens cleaning wipes because it says it contains isopropyl alcohol so can I use that

さんによる

コメントを追加

回答を追加する

Mark Whittaker さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 13

今までの合計 7,164