メインコンテンツにスキップ

Sostituzione batteria MacBook Air 13" metà 2011

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての10個のガイドに反映されます。

英語
イタリア語

手順 3を翻訳中

手順3
MacBook Air 13" Mid 2011 Battery Replacement: 手順 0、 1の画像 1
  • When handling the battery, avoid squeezing or touching the four exposed lithium polymer cells.

  • Lift the battery from its edge nearest the logic board and remove it from the upper case.

  • When installing the new battery, if there is a thin plastic film on your replacement battery, do not attempt to remove it. It is glued on and protects the battery pack while it is inside the MacBook.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Then, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.

Quando maneggi la batteria, fai attenzione a non premere o toccare le quattro celle a polimeri di litio.

Alza la batteria dal lato più vicino alla scheda logica e rimuovila dalla parte superiore del case.

Quando installi la nuova batteria, se c'è un sottile strato di plastica sulla tua batteria sostitutiva, non cercare di rimuoverlo. È incollato alla stessa e serve a proteggere il pacco batterie quando è installato nel MacBook.

Se stai installando una nuova batteria, dovresti calibrarla dopo l'installazione:

Caricala al 100% e lasciala caricare per altre due ore. Poi, scollegala e lascia che si scarichi normalmente. Quando vedi il segnale di batteria scarica, salva tutto il tuo lavoro, e lascia che il portatile si spenga per via della batteria scarica. Aspetta almeno 5 ore, e poi ricarica il portatile ininterrottamente fino al 100%.

Se noti qualsiasi comportamento anomalo o problemi dopo l'installazione della nuova batteria, probabilmente dovrai resettare il SMC del MacBook.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります