注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての14個のガイドに反映されます。
手順 11を翻訳中
手順11
Remove the logic board screws
-
Remove the following 8 screws:
-
Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
-
Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
-
One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
-
Note for re-assembly:
-
The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。