メインコンテンツにスキップ

Sostituzione batteria iPhone 3G

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての14個のガイドに反映されます。

手順 2を翻訳中

英語
イタリア語
手順2
iPhone 3G Battery Replacement, Loosen the display: 手順 0、 1の画像 1
Loosen the display
  • Remove the metal handle from the suction cup. It's easier and safer to grip the suction cup's base instead of the metal handle.

  • Be very careful when opening the iPhone so that the cables under the display are not severed.

  • There is a rubber gasket between the silver front bezel and black display assembly. A bit of force is required in this step to separate the iPhone's display assembly. It may help to rock the suction cup back and forth to remove the display assembly.

  • Use a small suction cup near the Home button to gently pull up the bottom portion of the iPhone's display assembly.

  • If the display assembly is too damaged to allow the suction cup to adhere, tape with a strong adhesive such as duct tape or packing tape may be used.

Rimuovi la maniglia di metallo dalla ventosa. È più facile e sicuro afferrare la base della ventosa anziché la maniglia di metallo.

Fai molta attenzione quando apri l'iPhone in modo che i cavi sotto lo schermo non vengano tagliati.

C'è una guarnizione in gomma tra la cornice anteriore cromata e il gruppo schermo nero. In questo passaggio è necessaria un po' di forza per separare il gruppo schermo dell'iPhone. Potrebbe essere utile far oscillare la ventosa avanti e indietro per rimuovere il gruppo schermo.

Usa una piccola ventosa vicino al pulsante Home per sollevare delicatamente la parte inferiore del gruppo schermo dell'iPhone.

Se il gruppo schermo è troppo danneggiato per consentire alla ventosa di aderire, è possibile utilizzare nastro adesivo forte come il nastro americano o il nastro da imballaggio.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります