メインコンテンツにスキップ

iPhone 6sのディスプレイの交換

英語
日本語

手順 1を翻訳中

手順1
iPhone 6s Display Replacement: 手順 0、 1の画像 1
  • While holding the front panel open at about a 90º angle, remove the following screws securing the front panel assembly cable bracket:

  • Three 1.3 mm Phillips #00 screws

  • One 3.0 mm Phillips #00 screw

  • Don't lose track of this screw! It's very important that the one 3.0 mm screw goes in the top-right corner of the plate. Anywhere else may cause damage to the logic board.

フロントパネルを90度に開いて固定する間、フロントパネルアセンブリのケーブルブラケットから次のネジを外します。

1.3 mm プラス #00ネジー3本

3.0 mm プラス #00ネジー1本

これらのネジを失くさないようにご注意ください!特に 3.0 mmのネジはプレートの上部右端に留められており、重要な役割を果たしています。紛失の場合はロジックボードにダメージを与えてしまうことがあります。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります