メインコンテンツにスキップ

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 5を翻訳中

手順5
Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board. To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery. Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.
  • Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.

  • To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery.

  • Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.

  • Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try using a playing card to disconnect the battery instead.

  • The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at a 15 degree angle.

  • Leave the battery blocker in place as you work.

バッテリーコネクタをロジックボードに固定している2.3mm #000プラスネジを1本外します。

ショートのリスクを減らすため、バッテリーの接続を外す際には、バッテリー絶縁ピックを使用できます。

バッテリーブロッカーを使用してバッテリーを分離するときは、十分に注意してください。バッテリーの接点は簡単に損傷してしまい、致命的なダメージを引き起こします。

ロジックボードのバッテリーコネクタ領域の下にバッテリー絶縁ピックをスライドさせます。ネジが外れるまで、その場所に置いておきます。

[* red] Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.
[* icon_note] To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery.
-[* icon_caution] Be very careful when you isolate the battery using a battery blocker. The battery contacts are easily damaged, resulting in irreversible damage.
- [* black] Slide a battery isolation pick underneath the battery connector area of the logic board, and leave it in place while you work.
+[* black] Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.
+ [* icon_note] Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try [guide|143682|using a playing card|new_window=true] to disconnect the battery instead.
+ [* icon_note] The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at a 15 degree angle.
+[* black] Leave the battery blocker in place as you work.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります