手順 13を翻訳中
手順13
Reinstall the Gear / Burr holder assembly
-
With the following pieces aligned carefully set the gear assembly into place:
-
Avoid rotating these pieces to maintain alignment.
-
As you set the assembly into place, make sure the two stop-screws are on the left side of the black plastic stop.
-
Align the large peg with the wide slot.
-
Align and the small peg with the small slot.
-
Press down on the gear assembly to snap it into place.
-
Once in place, rotate the coarseness knob through the full range to make sure it's all working.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。