手順 3を翻訳中
手順3
Insert New LED
-
Place the new LED through the open holes
-
The LED should cover the schematic symbol on the circuit board and the flat edge of the LED should line up with the tip of the diode symbol shown by the arrow
-
If the LED does not stay, you can tape it in place on the opposite side of the board
-
Warm up the trace on the circuit board and the LED lead with the soldering iron
-
Apply solder to the lead until the hole completely fills with solder
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。