はじめに

An Error 99 is an non specific error which means that camera doesn't know or have a code for the problem. In my case the shutter assembly needed replacing. This was a fairly involved process for a beginner such as myself.

This is not a comprehensive guide but should be used in conjunction with the Canon Service Manual and youtube videos. I hope that some of the pictures I took along the way might help you identify or remember how each step works.

パーツ

パーツは必要ありません。

Get the Canon 40D Service Repair Manual
  • Get the Canon 40D Service Repair Manual

  • Have a clean and organized workspace. I labelled plastic trays by step number and put all items for each step in a separate tray.

  • Watch a couple Youtube videos on this process

コメントを追加する

Peel off rubber grips Peel off rubber grips
  • Peel off rubber grips

コメントを追加する

take off front piece
  • take off front piece

コメントを追加する

take off rear connectors disconnect by flipping black/brown tab up and sliding plastic tab out.
  • take off rear

  • connectors disconnect by flipping black/brown tab up and sliding plastic tab out.

コメントを追加する

Take off top cover Take off top cover Take off top cover
  • Take off top cover

コメントを追加する

take off bottom plate disconnect and remove bottom board disconnect and remove bottom board
  • take off bottom plate

  • disconnect and remove bottom board

コメントを追加する

remove CMOS assembly
  • remove CMOS assembly

コメントを追加する

remove metal back
  • remove metal back

  • remove and replace shutter assembly, transfering components that aren't on the new one

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

leggman7

351 ポイント

1ガイドが承認済み

コメント1件

how do you replace the bridge (male portion on camera) other than putting the card in a card reader

wareibevictoriap - 返信

コメントを追加する

統計データを表示:

過去 24時間: 3

過去 7 日: 22

過去 30 日: 108

今までの合計 3,382