メインコンテンツにスキップ

iPad Pro 12.9インチ ディスプレイアセンブリの交換

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 23を翻訳中

手順23
iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 1 iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 2 iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 3
  • The display cables in this iPad are very short. Read the next two steps before you proceed.

  • Do not tilt the screen about the lower edge. The display cables don't have enough slack to allow for this.

  • Lift up the upper edge of the screen and slide the entire screen towards the front-facing camera to access the iPad's internal components.

  • The display cables will tear if you raise the screen more than 80 degrees.

  • Use masking tape to tape the lower edge of the screen to the frame to prevent the screen from slipping.

このiPadのディスプレイケーブルは非常に短いです。次の2つの手順を確認してから、作業を始めてください。

スクリーン下端を中心にしてさせないでください。ディスプレイケーブルには十分な余裕の長さがありません。

スクリーンの上端を持ち上げ、スクリーン全体を前面カメラに向かってスライドさせると、iPadの内部コンポーネントにアクセスできます。

スクリーンを80°以上上げると、ディスプレイケーブルが切れてしまいます。

スクリーンの下端をマスキングテープでフレームに貼り付けて、スクリーンのズレを防止してください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります