メインコンテンツにスキップ

Reemplazo de la batería del iPad 2 GSM

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
スペイン語

手順 1を翻訳中

手順1
iPad 2 GSM Battery Replacement: 手順 0、 3の画像 1 iPad 2 GSM Battery Replacement: 手順 0、 3の画像 2 iPad 2 GSM Battery Replacement: 手順 0、 3の画像 3
  • Reheat the iOpener in the microwave for one minute.

  • Remember to be careful not to overheat the iOpener during the repair procedure. Wait at least two minutes before reheating the iOpener, and never microwave it for more than one minute.

  • Place the heated iOpener on the back of the iPad just right of center (the side opposite the rear facing camera). Let it sit there for 90 seconds to soften the battery adhesive.

  • Move the iOpener to the center of the back of the iPad and let the iOpener sit for another 90 seconds.

  • If the iOpener cools significantly between sittings, reheat it for another minute.

  • Move the iOpener to the left edge (the side with the rear facing camera) of the back of the iPad and let the iOpener sit for another 90 seconds.

Vuelve a calentar el iOpener en el microondas durante un minuto.

Recuerda tener cuidado de no sobrecalentar el iOpener durante el procedimiento de reparación. Espera al menos dos minutos antes de recalentar el iOpener, y nunca lo calientes en el microondas durante más de un minuto.

Coloca el iOpener calentado en la parte posterior del iPad justo a la derecha del centro (el lado opuesto a la cámara trasera). Déjalo ahí durante 90 segundos para ablandar el adhesivo de la batería.

Coloca el iOpener en el centro de la parte posterior del iPad y déjalo reposar otros 90 segundos.

Si el iOpener se enfría mucho entre sentada y sentada, vuelve a calentarlo durante un minuto más.

Mueve el iOpener hacia el borde izquierdo (el lado con la cámara trasera) de la parte posterior del iPad y deja reposar el iOpener otros 90 segundos.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります