メインコンテンツにスキップ

Microsoft Surface Pro 6 開口方法

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

手順1
Microsoft Surface Pro 6 Opening Procedure, Heat the screen: 手順 0、 1の画像 1
Heat the screen
  • Completely power off the Surface before you begin disassembly.

  • If the screen's glass is cracked, keep further breakage contained and prevent bodily harm during your repair by taping over the glass. Lay overlapping strips of clear packing tape over the display until all the glass is covered. Wear safety glasses to protect your eyes.

  • Heat an iOpener and apply it to the right edge of the Surface's screen for two minutes.

  • You may need to reheat and reapply the iOpener several times to get the Surface warm enough. Follow the iOpener instructions to avoid overheating.

  • A hair dryer, heat gun, or hot plate may also be used for more heat, but be careful not to overheat the Surface—the screen and internal battery are susceptible to heat damage.

解体作業を開始する前に、Surfaceの電源を切ってください。

スクリーンのガラスにヒビが入っている場合は、ガラスをテープで覆うことで、これ以上の破損を防ぎ、修理中の身体への危害を防ぎます。透明な梱包用テープを重ね合わせて、ガラスがすべて覆われるまでディスプレイを覆います。目を保護するために保護メガネを着用してください。

iOpenerを温めて、Surfaceのスクリーンの右端に2分間当てます。

Surfaceを十分に温めるためには、複数回にわたってiOpenerを温め直して当てる必要があるかもしれません。過熱を避けるために、iOpenerの指示に従ってください。

ヘアードライヤー、ヒートガン、ホットプレートなどでも加熱できますが、Surfaceを加熱しすぎないように注意してください。(スクリーンや内蔵バッテリーは熱による損傷を受けやすいためです)

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります