手順 2を翻訳中
手順2
-
Loosen the two Phillips head screws that hold the actuator in place. They do NOT need to be removed fully, just loosened.
-
Once loosened simply push up on the actuator and then push the screws out through the large holes just above them.
-
Once loose from the panel pull the actuator out, away from the front of the car and the lock shaft will pull out of the hole where it enters the fuel filler opening.
-
Disconnect the vacuum "Y" connection from the fuel door lock actuator. At this point you can remove the actuator from the car for inspection.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。