手順 6を翻訳中
手順6
-
Remove the SAS backplane power cable by pulling the cable out of the board.
-
Remove the data cable from the board using a spudger to lift the connector out of the socket.
-
Loosen the Phillips #0 screw holding the backplane in the system.
-
To remove the backplane from the chassis, slide the board down, tilt it to a 45 degree angle, and pull the board out.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。