メインコンテンツにスキップ

MacBook Pro 15" Unibody Early 2011のバッテリーコネクタ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての69個のガイドに反映されます。

手順 1を翻訳中

英語
日本語
手順1
MacBook Pro 15" Unibody Early 2011 Battery Connector Replacement: 手順 0、 2の画像 1 MacBook Pro 15" Unibody Early 2011 Battery Connector Replacement: 手順 0、 2の画像 2
  • For certain repairs (e.g. hard drive), disconnecting the battery connector is not necessary but is recommended as it prevents any accidental shorting of electronics on the motherboard. If you do not disconnect the battery connector, please be careful as parts of the motherboard might be electrified.

  • Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.

  • It is useful to pry upward on both short sides of the connector to "walk" it out of its socket.

※特定の修理(ハードディスクドライブなど)の場合はバッテリーを取り外す必要はありませんが、マザーボード上で誤ってショートさせてしまうのを防ぐ事が出来るので推奨されます。バッテリーを外さない場合は、マザーボード上の部品が帯電している可能性があるので注意してください。

ナイロンスパッジャーの端を使って、バッテリーコネクターをメイン基板上のソケットから持ち上げてください。

ソケットから接続を外す際、コネクターの縦側の両サイドを上向きに持ち上げると簡単です。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります