注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。
手順 3を翻訳中
手順3
-
Remove the eight 9mm T9 Torx screws from the circuit board and back panel.
-
Use a metal spudger to release the ribbon cable connector and remove cable from the audio/USB board.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。