注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての7個のガイドに反映されます。
手順 2を翻訳中
手順2
-
Remove the two 9.5 mm T8 Torx screws from the WI-Fi board.
-
Lift the Wi-Fi board straight up from its socket in the upper metal case.
-
Leaving the Wi-Fi board antenna cable in place, move the Wi-Fi board aside, exposing the screw labeled "C3" that was beneath it.
| - | [* red] Remove the two 9.5 mm |
|---|---|
| + | [* red] Remove the two 9.5 mm T8 Torx screws from the WI-Fi board. |
| [* black] Lift the Wi-Fi board straight up from its socket in the upper metal case. | |
| [* black] Leaving the Wi-Fi board antenna cable in place, move the Wi-Fi board aside, exposing the screw labeled "C3" that was beneath it. |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。