メインコンテンツにスキップ

バッテリーのブロック

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 2を翻訳中

手順2
Battery Blocking, Battery connector information: 手順 0、 3の画像 1 Battery Blocking, Battery connector information: 手順 0、 3の画像 2 Battery Blocking, Battery connector information: 手順 0、 3の画像 3
Battery connector information
  • These photos show what the battery connector looks like underneath the logic board. Use these photos as a reference while you safely disconnect the battery.

  • Notice that the battery connector has cantilever springs on the logic board that press against the battery contact pads. Since both the logic board and battery are glued down, you'll need to slide something thin and flexible between the contact points to disconnect the battery.

これらの画像は、ロジックボードの下にあるバッテリーコネクターの外観を示しています。これを参考に、バッテリーを安全に取り外してください。

バッテリーのコネクターは、ロジックボード上にカンチレバースプリングがあり、バッテリーのコンタクトパッドに押し付けられていることに注意してください。ロジックボードとバッテリーの両方が接着されているため、バッテリーを取り外すには、何か薄くて柔軟なものを接点の間に滑らせる必要があります。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります