メインコンテンツにスキップ

Procedura di Apertura (3 Gen)

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
イタリア語

手順 23を翻訳中

手順23
Opening Procedure (3rd Gen), Unscrew the ambient light sensor cable bracket: 手順 0、 2の画像 1 Opening Procedure (3rd Gen), Unscrew the ambient light sensor cable bracket: 手順 0、 2の画像 2
Unscrew the ambient light sensor cable bracket
  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

  • Use a Phillips screwdriver to remove the two screws securing the ambient light sensor cable bracket to the logic board:

  • One 1.3 mm screw

  • One 2.0 mm screw

  • During reassembly, this is a good point to power on your iPad and test all functions before sealing it up. Be sure to power your iPad back down before you continue working.

Durante questa riparazione, tieni traccia di ogni vite e assicurati che torni esattamente da dove è venuta.

Utilizza un cacciavite a croce Phillips per rimuovere le due viti che fissano la staffa del cavo del sensore di luce ambientale alla scheda logica:

Una vite da 1,3 mm

Una vite da 2,0 mm

Durante il rimontaggio, questo è un buon momento per accendere l'iPad e testare tutte le funzioni prima di sigillarlo. Assicurati di spegnere nuovamente l'iPad prima di continuare a lavorare.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります