メインコンテンツにスキップ

光学ドライブの取り外し

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 4を翻訳中

手順4
Optical Drive Removal, Remove the vibration isolator: 手順 0、 3の画像 1 Optical Drive Removal, Remove the vibration isolator: 手順 0、 3の画像 2 Optical Drive Removal, Remove the vibration isolator: 手順 0、 3の画像 3
Remove the vibration isolator
  • Lift up the optical drive's vibration isolator to remove it.

  • The vibration isolator grips the sides of the optical drive with silicone pads, so you may need to "walk" the isolator off of the drive to slip it off each side.

  • During reassembly, ensure the vibration isolator is pushed down and around both edges of the optical drive, so it sits flush with the rest of the center chassis.

光学ドライブのバイブレーションアイソレーター(防振材)を持ち上げます。

バイブレーションアイソレーターは光学ドライブの側面をシリコンパッドで防振台を装着しています。両側から防振材を取り出すには、少しずつ”ずらしながら” 外してください。

再組み立ての際には、防振材が光学ドライブの両端に挟まれていることを確認し、中央のシャーシと同じ高さになるように配置します。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります