手順 10を翻訳中
手順10
Soldering the new part into place
-
This is the tricky part. You should probably use a small pinching clip to hold the sim reader in place, and if you haven't got much experience with micro soldering, I strongly advice using two hands to steady your iron.
-
Apply a small amount of flux onto the legs and pads, and then touch one pad. At this point, having a microscope comes in handy, because you can see the solder melt.
-
After that just proceed touching the legs one by one, soldering all 8 legs onto the logic board.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。