注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての2個のガイドに反映されます。
手順 3を翻訳中
手順3
-
Place the phone with the screen facing down onto a flat surface.
-
Place the flat edge of the pry tool into the seam on the side, just above the screen. (refer to picture on where to place pry tool).
-
Push the pry tool into the seam.
-
Pry apart the plates until the cover separates from the rest of the phone. Be careful not to apply too much pressure
-
Proceed to pull the front cover away from the rest of the phone. (refer to second picture for results) The marking foreshadows what we will be using in the next step.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。