手順 7を翻訳中
手順7
Peel Tape and Unscrew T-Con Buffer Board Cover
-
Peel off black tape surrounding the cover. Careful around the 3 connector regions (notes below) Peel off foil tape at the 2 ends of cover. Remove 4x phillips screws.
-
LCD connector is very difficult. Its a flip latch connector with a handle tape just like the other end of cable. The handle tape covered under 2 differnet sticky tapes.
-
First peel off the black tape and carefully separate the LCD connector latch handle tape.
-
Next peel off the aluminum tape and latch handle tape is finally liberated.
-
Note iMac LCD (same model as TB Display) may seal this connector area differently from Thunderbolt Display LCD.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。