メインコンテンツにスキップ

Motorola Moto Xバックカバーアセンブリの交換

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての9個のガイドに反映されます。

手順 6を翻訳中

英語
日本語
手順6
Motorola Moto X Back Cover Assembly Replacement: 手順 0、 3の画像 1 Motorola Moto X Back Cover Assembly Replacement: 手順 0、 3の画像 2 Motorola Moto X Back Cover Assembly Replacement: 手順 0、 3の画像 3
  • Starting from the SIM slot side, carefully peel the back cover off of the phone.

  • The back cover is very flexible, but you don't want to damage any internal components by being too hasty.

  • There is a chance that the NFC coil may remain stubbornly adhered to the back cover. If that's the case, stop peeling the cover and reapply a heated iOpener to the back cover.

  • Do not separate the back cover entirely; it is still connected to the phone by the camera flash cable.

  • The flash cable is attached on the power/volume button side of the phone.

SIMスロット側から、デバイスのリアカバーを慎重に剥がします。

リアカバーは非常に柔軟性がありますが、作業を急ぎぎて内部コンポーネントに損傷を与えないようご注意ください。

NFCコイルがリアカバーに付着して剥がれない可能性があります。 その場合は、カバーを剥がす作業を中断して、温めたiOpenerをリアカバー上に載せてください。

リアカバーを完全に外さないでください。 カメラのフラッシュケーブルがデバイスに接続されたままです。

フラッシュケーブルは、デバイスの電源/音量ボタン側に接続されています。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります