メインコンテンツにスキップ

バッテリーのブロック

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての10個のガイドに反映されます。

英語
日本語

手順 1を翻訳中

手順1
Battery Blocking, Disconnect the battery: 手順 0、 2の画像 1 Battery Blocking, Disconnect the battery: 手順 0、 2の画像 2
Disconnect the battery
  • Use a Phillips screwdriver to remove the 1.8 mm screw securing the battery connector to the logic board.

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

プラスドライバーを使って、ロジックボードにバッテリーコネクタを固定している1.8 mmねじを1本外します。

この修理の作業中、各ねじの装着位置をメモ書きしてください。正しい位置に装着しているか確認してください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります