Bicycle Handlebar Tape Replacement手順の4履歴

	[* black] Peel off a few feet of the adhesive backing on the roll of new bar tape.
	[* black] Affix the center of the end of the tape with the edge of the drop bar, so that half of the width of the tape hangs over the end of the bar.
-	[* black] Begin to snugly wrap the tape up the handlebar, peeling off more adhesive backing as needed and overlapping each new layer of tape by one half of its width.
+	[* black] Begin to snugly wrap the tape up the handlebar, pulling the tape up and over the handlebar toward the bicycle (counterclockwise).
+	[* black] As you wrap, peel off more adhesive backing as needed and overlap each new layer of tape by one half of its width.
+	[* black] When wrapping the tape around curves in the handlebars, allow for more overlap on the inside of the curve and less overlap on the outside of the curve.