手順1に変更
- Tim Ellisonによって編集
承認済みの編集 : Tim Ellison
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Removing the metal backplate is simple. This is just stuck on with some flexible glue. |
|---|---|
| + | [* black] Removing the metal backplate is simple. This is just stuck on with some flexible glue. So prise something under and off it pops. |
| [* black] Inside you can see a number of large cut outs in the rear of the plastic casing. | |
| [* red] Note the small pinhole in the metal backplate that aligns with the rubber sealed hole in the plastic casing - more on that later. | |
| [* yellow] There is also a very small ground out area inside the metal backplate that appears to align with the rotating mass of the vibrator. |