手順12に変更
- Clay Eickemeyerによって編集
承認済みの編集 : Clay Eickemeyer
- 前
- 後
- 変更なし
手順ライン
| [title] Soften the top edge adhesive | |
| - | [* black] Apply a [guide|25705|heated iOpener|new_window=true] to the top edge of the screen for 3 minutes. |
| - | [* icon_note] You can also use a heat gun or hair dryer to heat the screen. Be careful not to overheat it, as the LCD panel and top edge sensors are susceptible to heat damage. |
| - | [* icon_note] While you wait for the adhesive to soften, note where it is along the top edge: |
| - | [* red] The adhesive is 3 mm deep, with a second strip 6 mm deep on the magnet, 6.9 cm from the left edge of the screen. |
| + | [* black] Apply a [guide|25705|heated iOpener|new_window=true] to the top edge of the screen for 2 minutes. |
| + | [* icon_note] You can also use a heat gun or hair dryer to heat the screen. Be careful not to overheat the top edge sensors. |
| + | [* icon_note] While you wait for the adhesive to soften, note the following: |
| + | [* red] The left section of adhesive reaches 69 mm (2.7 in) from the left edge of the screen. It's 3 mm deep, with a thin strip 6 mm deep on the magnet. |
| + | [* orange] The middle section of adhesive is 2 mm deep. |
| + | [* yellow] The right section of adhesive reaches 84 mm (3.3 in) from the right edge of the screen. It's also 3 mm deep, with a thin strip 6 mm deep on the magnet. |