手順1に変更
- Grace Giusによって編集
承認済みの編集 : Grace Gius
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Put ventilator into diagnostic mode: |
|---|---|
| - | [* black] Begin with ventilator powered off |
| - | [* black] Press ALARM RESET and 100% O2 keys located on the right of the front panel key section (as shown in Figure 8-2) for approximately 5 seconds while turning ventilator power on |
| - | [* black] Touch OK to enter diagnostic mode |
| + | [* black] Put ventilator into diagnostic mode (page 8-21 in [document|7525|Service Manual]): |
| + | [* black] Begin with ventilator powered off. |
| + | [* black] Press ALARM RESET and 100% O2 keys located on the right of the front panel key section (as shown in Figure 8-2) for approximately 5 seconds while turning ventilator power on. |
| + | [* black] Touch OK to enter diagnostic mode. |