RCA RCT6203W46 Rear Camera Replacement

最終更新日: December 18, 2016

見積もりなし

中レベル

はじめに

In order to replace a broken front or rear camera, you will need to follow this guide. There are several steps and you will need to be careful when taking apart this device.

必要な工具と部品

ツール

RCA RCT6203W46 Rear Camera Replacement, Front and Rear Camera: 手順 1、 2の画像 1

RCA RCT6203W46 Rear Camera Replacement, Front and Rear Camera: 手順 1、 2の画像 2

Make sure the device is off to reduce the chance of an electrical shock. To turn off the device, press and hold the power button.
Use a Phillips #00 Screwdriver to unscrew the 4mm (5/32 in.) screws from the back cover of the tablet.

編集

手順2

Use a spudger to pry the back cover. Start from one edge of the back cover and slide across until the cover is lifted from the tablet body. Repeat for all edges.

編集

手順3

Open the tablet cover carefully and slowly lengthwise.
The keyboard wire ribbon and rear speaker wire should be intact and connected with the back cover.
Opening the tablet abruptly may tear or damage cover attachments.

編集

手順4

Use a spudger to flip up the flap of the ZIF connector that holds the keyboard wire ribbon.
Remove the wire ribbon from clamp.

編集

手順5

Attached to the motherboard you will see two orange ribbons connected to black tabs.
Using both hands, place your thumbs gently on the black tab attached to the top and gently lift it.
Proceed to slide the orange colored ribbon out from underneath until it is detached from the black tab.

編集

手順6

Use a spudger to pry and slide underneath the battery to unstick it from the LCD metal plate. It may take a good amount of force to remove.
Try to decrease battery deformation by using a spudger rather than prying with your hands.
Do not let battery fall back on adhesive, it will stick back onto the LCD metal plate.
Be careful to not puncture the battery. The battery may ignite or explode.

編集

手順7

Gently remove the grey tape that's covering the grey colored wire until it is completely peeled off.
Peel off the black piece of tape to remove the antenna.

編集

手順8

Unscrew three of the 4 mm screws on the motherboard using a Phillips #00 screwdriver.
After removing the screws, detach the motherboard from the rest of the tablet. Use a spudger to gently remove it, if necessary.

編集