Philips Norelco 5801XL Front and Back Housing Replacement

最終更新日: July 15, 2024

10 - 20 分

簡単

はじめに

We will show how to replace the housing of the device, on both the front or rear. This guide will be useful if the housing is cracked or broken, not so much so if the device itself does not work. No special skills are required for this easy fix! Prior to beginning the assembly please purchase replacements from the links provided on the troubleshooting page.

必要な工具と部品

パーツ

Replacement Housing

ツール

Philips Norelco 5801XL Front and Back Housing Replacement, Front and/or back housing: 手順 1、 2の画像 1

Philips Norelco 5801XL Front and Back Housing Replacement, Front and/or back housing: 手順 1、 2の画像 2

Remove the two T8 2 mm Phillips screws on the back housing.

翻訳

手順2

Separate the back housing and the front housing using the plastic opening tool.

翻訳

手順3

Philips Norelco 5801XL Front and Back Housing Replacement: 手順 3、 3の画像 3

Using the plastic opening tool, carefully pry the inside of the middle bracket towards the outside of the housing in order to remove it.

翻訳

手順4

Remove the two T8 2 mm screws near the bottom of the device.
Remove the bracket the screws were holding in place.

翻訳

手順5

Insert the plastic opening tool into the charging port and push inwards.

翻訳

手順6

Remove the two T8 2 mm screws near the top of the device shown here.

翻訳

手順7

Philips Norelco 5801XL Front and Back Housing Replacement: 手順 7、 3の画像 3

Cautiously lift and twist the circuit board, then begin sliding the inside assembly forward.
After sliding it forward, the whole assembly will separate from the rear housing.

翻訳