はじめに

This guide will show you how to replace the Mid Wall on from your laptop.

With the case closed, place the Unibody top-side down on a flat surface.
  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

コメントを追加する

The access door should now be raised enough to lift it up and out of the Unibody.
  • The access door should now be raised enough to lift it up and out of the Unibody.

コメントを追加する

Be sure the access door release latch is vertical before proceeding.
  • Be sure the access door release latch is vertical before proceeding.

  • Grab the white plastic tab and pull the battery up and out of the Unibody.

Great tutorial ! great step !

Leo Etcheverry - 返信

Remove the following eight screws securing the lower case to the chassis:
  • Remove the following eight screws securing the lower case to the chassis:

    • One 3 mm Phillips screw.

    • Three 13.5 mm Phillips screws.

    • Four 3.5 mm Phillips screws.

On my model, it seemed the top-left was 3.5mm and the bottom 4 were 3 mm.

Jim - 返信

Make sure you have a good quality Phillips screwdriver. Mine had removable tips and had a small play at the connection. As a result I didn't have a good feel and damaged my screws (those securing the fan and the top left in step 23). Game over for me installing new thermal paste...

Be very carefull with your screws! Especially those on the inside.

Nickolas Michelinakis - 返信

You can get away with a Phillips #00 for many of the screws involved but the 4 at the bottom case split are likely to strip if you don’t use a JIS #00 or, in a pinch, a Phillips #000.

Bill Cole - 返信

Using both hands, lift and remove the lower case off the upper case.
  • Using both hands, lift and remove the lower case off the upper case.

コメントを追加する

Remove the four 10.3 mm Phillips screws securing the mid wall to the upper case.
  • Remove the four 10.3 mm Phillips screws securing the mid wall to the upper case.

コメントを追加する

Lift the mid wall out of the upper case.
  • Lift the mid wall out of the upper case.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

6 の人々がこのガイドを完成させました。

Walter Galan

553,380 ポイント

2,839のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 8

過去 30 日: 34

今までの合計 20,047