HP Photosmart Premium C309g TouchSmart Display Screen Replacement

最終更新日: May 7, 2024

15 - 20 分

簡単

はじめに

Replace the TouchSmart display screen on the front of the printer. This screen serves as the main menu and control of all the machine's functions. If the screen becomes unresponsive or physically damaged, it may need to be replaced.

必要な工具と部品

ツール

手順1 TouchSmart Display Screen

HP Photosmart Premium C309g TouchSmart Display Screen Replacement, TouchSmart Display Screen: 手順 1、 1の画像 1

Open the top of printer. The printer should appear as shown.

編集

手順2

Use the blue plastic opening tool to pry the trim pieces all the way around the printer.
Loosen the pieces around the edges before pulling to remove from the printer.
Pull the (4) trim pieces off and set them aside.

編集

手順3

Using the blue plastic opening tool, pull from the middle and then slide back to remove the side panels.
The side trim pieces need to be removed before the front trim pieces.

編集

手順4

Using the T9 Torx Security screwdriver bit, unscrew the five 12mm screws shown.

編集

手順5

The scanner flap is attached by a clip that can be dislodged by pulling it gently away from the printer.
Keeping the scanner flap upright, slide it toward the unattached clip in order to dislodge the second clip.
Both clips will come unattached and you can set the scanner flap aside.

編集

手順6

Lift the scanner glass piece from the printer and set it aside.

編集

手順7

Gently pull the display screen away from the printer.
Locate & unscrew the two 12mm screws using the T9 Torx Security screwdriver bit.

編集

手順8

Place thumb and forefinger where shown and pull this piece away from the printer.
Do not pull it away too hard. The piece is still connected by wiring ribbon.

編集

手順9

この手順で使用する道具：

Tweezers

$4.99

カートに入れる

Pull both wiring ribbons out from the display screen piece. This will separate the piece from the printer.
Use tweezers if necessary.

編集

手順10

Push forward and down to release the retaining piece. This will detach the display screen from the front panel.

編集

手順11

Set the display screen face down.
Locate and unscrew all four 12mm screws on the back on the display screen using the T9 Torx Security screwdriver bit.

編集