はじめに

If you have identified that your record player needs to have its motor replaced, this guide will show you how to safely do so. The motor is what controls the speed the record plays at, and may wear down or completely fail over time and with use. Replacement is easy if these steps are followed. Note that it is first important to complete the Disassembly Guide.

  1. Remove the three brass screws using a phillips #1 screwdriver.
    • Remove the three brass screws using a phillips #1 screwdriver.

    コメントを追加する

  2. Cut the wires that are attached to the motor.
    • Cut the wires that are attached to the motor.

    • Be sure to note the attachment point so that the wires can be reattached to the new motor.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Using the phillips #1 screwdriver, remove the three screws that are holding the circular mounting bracket to the motor.

    • Remove the circular mounting bracket from the motor.

    コメントを追加する

    • Attach the mounting bracket to the new motor.

    • Insert the new motor.

    • Flip the turntable over making sure the motor stays in place, and insert the screws underneath the turntable.

    コメントを追加する

    • The ends of the wires will need to be stripped before soldering.

    • Be extremely careful not to burn yourself while soldering.

    • Solder the wires cut wires onto the motor in the location recorded previously.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order and complete the disassembly guide in reverse order.

Jake Hamilton

メンバー登録日: 2012年09月19日

134 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 2-61, Propen Fall 2012 Cal Poly, Team 2-61, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S2G61

4 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 5

今までの合計 1,271