メインコンテンツにスキップ

Repair information for the Crusher Wireless headphones. Model number: S6CRW-K591. First available on Amazon in August of 2016.

The turning mechanism between the earpad and the headband broke.

After almost one and half year my headphones just broke when I wanted to put them on. I was very surprised that this happened and I'm also very sad because I can't even wear them anymore. The sound and everything is just fine.

Block Image
Block Image
この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 6
4 件のコメント

Did you find a solution? I'm having the same problem and I'm looking for the replacement part to print it with the 3D print... But I can't find it...

さんによる

I duct taped it together until I got back home. (I was on an international internship). Then my dad gave me money to buy a new one.

さんによる

@Floortje B hahaha Ok thanks

さんによる

ok so I need the part that's still connected to the earmuff... the plastic piece with the 2 screws on the bottom of the first picture

さんによる

コメントを追加

3件の回答

最も参考になった回答

Floortje B  the only way you can fix that is by either having someone 3D print you a new part for it or you’ll find another pair that is broken other than the hinge part. Looks like the 2 screws are the only thing that hold those to your headphone. Removing those most likely enables you to replace the broken part.

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

I figured out a temporary fix. I am posting this for others arriving here from search engines and the like. I assume OP's problem has long been solved. My fix is based on somebody else's fix.

I have 3D printed parts on the way, but my 'design' may actually press down on my ears better than the original. 🤔

What you'll need:

-Tie rip 2 mm
-Tie rip 4 mm
-Drill + 1,5 mm drillbit for metal
-Strong thin elastic.

-Pliers (for making sure the tierips are real tight.)

Block Image



Alt for picture: https://imgur.com/a/TcRGRT2

このアンサーは役に立ちましたか?

スコア 1

2 件のコメント:

Great quick fix! If you find the time, create a step by step guide for this!

さんによる

@amber No time, this is what I got. It's pretty detailed already.

さんによる

コメントを追加

My device is broken exactly at the same point today. I fix it by drill a hole from one site to the other (1,2mm thick) and insert a steel pin (as it is used in watches). I used black tape to prevent fall out of the pin.

If anybody is 3D-printing original part, I would like to order one!

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

Floortje B さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 8

過去 30 日: 30

今までの合計 2,039