評価: 13
1
1
I bought the upper case of the 2.4 GHz Model and wanted to change it because the keyboard of that uppercase has back light. But the problem is my logic board does not have the connector for the led ribbon cable, but ifixit says that it should work and the upper cases are fully compatible. Are they interchangeable?
この質問は役に立ちましたか？
評価: 2.3千
16
4
1
Yes, They are interchangeable, yes, you do have that connection on your board, yes, when plugged in, they keyboard will light up.
The Backlight Connector is Beside the Keyboard connector,
このアンサーは役に立ちましたか？
I concur!
I apologise, this appears to be correct
評価: 13
1
1
Thanks for you answer...
But my Logic board really does not have the led ribbon cable connector.
Here is a pic of my Macbook:
http://www.siteki.de/macbook_unibody_2.0...
I hope you can help me.
このアンサーは役に立ちましたか？
Thanks for the picture, I'm not sure what to say, it should be there, and you can even see the solder mount of were the connector would go if it were actually present. Apple Makes two logic boards for this model, we call them "better" and "best." since "better" has the CTO option for backlit keyboards, all logic boards are manufactured with the connector. It appears that your board was either a manufacturing defect, or the connector somehow was broken off at some point.
評価: 37.6千
315
66
72
What is the little ribbon near your screwdriver ? And yes we can see the connector on your pict.
このアンサーは役に立ちましたか？
評価: 13
1
1
The ribbon cable is from the led sheet from my new topcase...The connector is not there, only the soldering contacts.
Does anybody know the right pin order?
Can i solder it with a normal cheap soldering iron or has it to be an anti static iron?
Sorry for my bad english, I am from germany ;-)
--
thanks
fufu87
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 11
今までの合計 2,499
