このユーザーはプロフィールを作成していません。
完全ガイド
回答
There should be a switch that the brake pedal activates when pushed in that switch is most likely going bad should be an easy fix
続きを読むThere is an Antenna Wire on the new Charging flex cable - Make sure this is connected -
続きを読むDid you remember to Transfer the Magnets from the old Digitizer to your replacement Digitizer?
続きを読むI have one right now doing the same thing - the customer thought it might be the charging port. It was a dead stick, so I put the tablet on a good Samsung 2.0amp charger and after about a day I started getting this flashing I have a battery one order and will test it out once it arrives.
続きを読むI recently did a repair on a similar Eureka with loud whistling - The Dirt Cup Gasket was missing - 83920-119N
続きを読むif you've changed the Inverter Board, Inverter cable, and the LCD panel.. unfortunately all that is left is the Logic board. Was the iBook dropped or subject to a liquid spill? as you know.. the backlight is inside the LCD panel..
続きを読むDid you replace just the LCD Panel, or the entire assembly? This Model is LED Backlit, therefore no inverter, backlight or inverter cable. Power for the Display LED's ride along with the LVDS Cable. since your getting display but not power, and both come from the same cable, its hard to determine without alittle troubleshooting.. replacing the cable would be a good start.. actually would have been the first step. a backlight problem would rarely be the LCD on this model.
続きを読むWith an external hard drive, you can back up your data , then restore from the backup on the new PS3. Using the Backup utility.. More info on sony's website.. http://playstation.custhelp.com/app/answ...
続きを読むDo each of these computers have assigned Static IP Address's? it not 10.0.1.4 may not be the computer you think it is.. if you don't like the idea of static, the next best thing would be to setup a DHCP reservation in your router. that way the router always assigns the correct IP address based on MAC address.
続きを読むYes, that cable is integrated into the LCD panel itself. it technically could be repaired by someone who is skilled in wire repair / soldering.
続きを読むページ11の1
修理ガイドのコメント
t4 works better for these screws
matthewfrey
@matthewfrey
2,347
ポイント
104
回答
0
ガイド
メンバー登録日 10/15/09
Former Apple Certified Technician
チーム
投票
12
11