メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての14個のガイドに反映されます。

英語
日本語

手順 7を翻訳中

手順7
The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed. As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.
  • The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.

  • As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.

  • Use the opening picks to slice through any remaining adhesive and open the phone slightly.

  • If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.

  • During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.

  • Remove the glass from the phone.

指紋認証センサーケーブルがメインカメラ付近のリアグラスとデバイス本体を繋げています。ケーブルは大変短く、リアグラスを取り外す際に接続を外してください。

ガラスを持ち上げたら、内部を覗いてオレンジのケーブルとブルーのコネクターの接続が外れているか確認してください。

開口ピックを使って、残りの圧着剤を綺麗に取り除き、デバイス本体を少し開きます。

指紋認証センサーケーブルが引っ掛かったり、突っ張った状態でデバイス本体がこれ以上開かない場合は、次の手順に進む前にスパッジャーの先端でコネクターの接続を外してください。

本体からガラスを取り出します。

[* icon_note] The fingerprint sensor cable connects the phone to the rear glass near the main camera. The cable is very short and should disconnect as the rear glass is removed.
[* icon_caution] As you lift the glass, peek in to be sure the orange cable with a blue connector has disconnected.
[* black] Use the opening picks to slice through any remaining adhesive and open the phone slightly.
[* icon_caution] If the fingerprint sensor cable seems snagged or stays taut do not open the phone any further. Disconnect the connector with the point of a spudger before proceeding.
[* icon_reminder] During reassembly, in order to reconnect the fingerprint sensor cable, first angle the back cover into position until the cable connector lines up perfectly over its socket. Then, use the flat end of your spudger to gently snap the connector into place by pressing it straight down.
[* black] Remove the glass from the phone.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります