修理を始めるには コミュニティ ストア

Sostituzione cover posteriore Nintendo 3DS

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての25個のガイドに反映されます。

ガイドに戻る
英語
イタリア語
次の手順

手順 1を翻訳中

手順1
Nintendo 3DS Back Cover Replacement, Loosen the rear screws: 手順 0、 1の画像 1
Loosen the rear screws

  • Use a Phillips PH00 screwdriver to loosen the four screws along the top of the back cover.

  • All screws in this device are JIS screws. Official iFixit PH000-PH1 Phillips screwdrivers are designed to be compatible with JIS screws, so they are safe to use. Using a screwdriver other than an official iFixit screwdriver or a JIS screwdriver may result in stripped screws.

  • The screws are held in place by locking washers, and will not come out of the back cover.

ここに翻訳を挿入する

Usa un cacciavite Phillips PH00 per allentare le quattro viti lungo la parte superiore della cover posteriore.

Tutte le viti in questo dispositivo sono viti JIS. I cacciaviti Phillips PH000-PH1 ufficiali di iFixit sono progettati per essere compatibili con le viti JIS, quindi sono sicuri da usare. Usare un cacciavite diverso da un cacciavite ufficiale iFixit o da un cacciavite JIS potrebbe causare lo spanamento delle viti.

Le viti sono tenute in posizione da rondelle di bloccaggio e non usciranno dalla cover posteriore.

+[title] Loosen the rear screws
[* red] Use a Phillips PH00 screwdriver to loosen the four screws along the top of the back cover.
[* icon_note] All screws in this device are [guide|93991|JIS screws|stepid=176809|new_window=true]. Official [product|IF145-006|iFixit PH000-PH1 Phillips screwdrivers|new_window=true] are designed to be compatible with JIS screws, so they are safe to use. Using a screwdriver other than an official iFixit screwdriver or a JIS screwdriver may result in [guide|13213|stripped screws|new_window=true].
[* icon_note] The screws are held in place by locking washers, and will not come out of the back cover.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。