注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。
手順 2を翻訳中
-
Twist the opening pick to fully dislodge the battery and remove it.
-
Remove any remaining adhesive from the phone, and clean the glued areas with isopropyl alcohol and a lint-free cloth.
-
Lay the replacement battery in place, but do not apply adhesive yet. Resume re-assembly until the motherboard is in place (STEP 18).
-
Apply new pre-cut adhesive or double-sided tape onto the phone frame, around the perimeter of the battery compartment, but not in the rectangular cutout in the center (which is actually the back side of the display).
-
Temporarily connect the battery connector to the motherboard to ensure proper battery alignment.
-
Press the battery firmly into place for 5-10 seconds. Disconnect the battery and resume re-assembly.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。