メインコンテンツにスキップ

iPad Pro 12,9" (5. Generation ) öffnen

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
ドイツ語

手順 2を翻訳中

手順2
iPad Pro 12.9" 5th Gen Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 1 iPad Pro 12.9" 5th Gen Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 2 iPad Pro 12.9" 5th Gen Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 3
Anti-Clamp instructions
  • The next three steps demonstrate the Anti-Clamp, a tool we designed to make the opening procedure easier. If you aren't using the Anti-Clamp, skip down three steps for an alternate method.

  • For complete instructions on how to use the Anti-Clamp, check out this guide.

  • Pull the blue handle backwards to unlock the Anti-Clamp's arms.

  • Place an object under your iPad so it rests level between the suction cups.

  • Position the suction cups near the middle of the right edge—one on the top, and one on the bottom.

  • Hold the bottom of the Anti-Clamp steady and firmly press down on the top cup to apply suction.

  • If you find that the surface of your iPad is too slippery for the Anti-Clamp to hold onto, use tape to create a grippier surface.

Wir haben die Anti-Clamp entwickelt, um das Öffnen von Geräten zu erleichtern. Die nächsten drei Schritte zeigen, wie sie verwendet wird. Wenn du sie nicht benutzen willst, überspringe die nächsten drei Schritte und folge einer anderen Methode.

Genaue Anweisungen für die Anti-Clamp findest du hier.

Drücke den blauen Griff zurück, damit die Arme frei beweglich werden.

Lege das iPad auf einen Gegenstand, so dass es waagrecht zwischen den beiden Saugheber aufliegt.

Bringe die Saugheber mittig nahe an der rechten Seitenkante des iPads an, einen auf der Vorderseite, den anderen auf der Rückseite.

Halte die Anti Clamp unten gut fest und drücke kräftig auf den oberen Saugheber, um sie gut zu befestigen.

Wenn die Saugheber nicht gut haften, dann klebe Paketband über die Oberfläche des Gerätes, damit sie griffiger wird.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります