メインコンテンツにスキップ

Google Pixel 6a スクリーンの交換

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

手順1
Google Pixel 6a Screen Replacement, Reassembly information: 手順 0、 3の画像 1 Google Pixel 6a Screen Replacement, Reassembly information: 手順 0、 3の画像 2 Google Pixel 6a Screen Replacement, Reassembly information: 手順 0、 3の画像 3
Reassembly information
  • Remove the screen.

  • During reassembly:

  • If you replaced your screen, check the front-facing camera hole and the sensor cutout on your replacement screen, and remove any remaining liners.

  • Check your phone if the proximity sensor's rubber gasket is missing—it might be stuck to the back of your old screen. Replace it if necessary.

  • This is a good point to test your phone before sealing it up. Temporarily connect your screen, power on your phone, and make sure it works as expected. Before continuing with reassembly, power off your phone.

  • Remember to reinstall the display cable bracket.

  • Follow this guide to replace the screen adhesive.

  • If you're installing a new screen, follow this guide to calibrate the fingerprint sensor.

これでスクリーンが取り外せるようになります。

組み立て直す際は以下のことに注意して下さい。

スクリーンを交換した場合、交換したスクリーンのフロントカメラ用の穴とセンサーの切り欠きが合っているか確認し、残りのライナーを剥がしてください。

近接センサーのゴム製ガスケットがなくなっていないか確認して下さい。交換前のスクリーンに貼り付いていることがあります。必要に応じて新しいものに交換して下さい。

スクリーンを接着する前に正しく機能するかどうか確認するなら、この時点で行いましょう。スクリーンを一時的に接続してから電源を入れて、修理が上手く行ったか確認しましょう。組み立て直し始める前に必ず電源を切って下さい

ディスプレイケーブルブラケットを忘れずに再装着してください。

こちらのガイドを参照して、スクリーンに接着剤を装着してください。

新しいスクリーンに交換する場合は、こちらのガイドに従って指紋認証センサーのキャリブレーションを行って下さい。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります