メインコンテンツにスキップ

スクリーンの外し方

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 4を翻訳中

手順4
Screen Removal: 手順 0、 2の画像 1 Screen Removal: 手順 0、 2の画像 2
  • Heat an iOpener and thread it through the arms of the Anti-Clamp so it lays on the right edge of the phone.

  • You can also use a hair dryer or heat gun—but extreme heat can damage the display and/or internal battery, so proceed with care.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen frame when the Anti-Clamp creates a large enough gap.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle clockwise half a turn.

  • Don't crank more than a half a turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next two steps.

温めたiOpenerをリバースクランプのアームに画像のように通して、デバイスの右側端の上に載せます。

ヘアドライヤーヒートガンなどを使うこともできますが、温めすぎるとディスプレイや内蔵バッテリーにダメージを与えることがありますので、注意してください。

1分ほど待つと、接着剤が剥がれてきて、隙間ができます。

クランプで十分な隙間ができたところで、スクリーンのフレーム下にオープニングピックを挿入します。

クランプで十分な隙間ができない場合は、その部分に少し温めて、ハンドルを時計回りに半回転させてください。

一度に半回転以上回さないで下さい。さらに回したい時は1分ほど待ってから半回転だけ回して下さい。リバースクランプでの開口作業は時間がかかります。

次の2つの手順はスキップしてください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります