はじめに

This guide will help you take apart, clean, and (if necessary) replace the palm treo keyboard.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

コメントを追加する

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

コメントを追加する

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

コメントを追加する

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

コメントを追加する

MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

コメントを追加する

Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

コメントを追加する

Unclip the gray tab. Pull out the orange ribbon cable. Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!
  • Unclip the gray tab.

  • Pull out the orange ribbon cable.

  • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

コメントを追加する

Pull off the mother board. Install replacement or repaired motherboard, reversing steps above.
  • Pull off the mother board.

  • Install replacement or repaired motherboard, reversing steps above.

コメントを追加する

Unscrew the two 3.2 mm screws with a Phillips #00 screwdriver.
  • Unscrew the two 3.2 mm screws with a Phillips #00 screwdriver.

コメントを追加する

Pull off the circuit board.
  • Pull off the circuit board.

コメントを追加する

Remove the keypad for cleaning or replacing.
  • Remove the keypad for cleaning or replacing.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

cgood

メンバー登録日: 2009年10月28日

116 ポイント

14のガイドは作成済み

チーム

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009人のメンバー

CPSU-MANESS-F09S19G3

4 メンバー

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 4,491