修理を始めるには コミュニティ ストア

DigiTech RP70 LED Light Replacement

作成者： Elijah Smith (そして 3 人のその他投稿者)
  • コメント: 0
  • お気に入り: 0

難易度

難しい

手順

5

所要時間

15 - 30 分

セクション

2

フラグ

0

はじめに

If the LED light is broken, or dead, this guide will teach you how to remove the broken component for replacement.

ツール

パーツ

パーツは指定されていません。

  1. Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks. Remove the four 8mm Phillips #0 screws located on the back panel.

    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

    編集

  2. Remove the back panel to expose the motherboard. Remove the back panel to expose the motherboard.

    • Remove the back panel to expose the motherboard.

    編集

  4. Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

    編集

  5. Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

    編集

  6. Desolder the back of the motherboard where the LED light is located.

    • Desolder the back of the motherboard where the LED light is located.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

3他の投稿者と一緒に

Elijah Smith

メンバー登録日: 2018年09月10日

726 ポイント

6のガイドは作成済み

バッジ: 10

+7 個以上のバッジ

チーム

Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 Appalachian State University, Team S2-G2, Menagarishvili Fall 2018人のメンバー

APSU-MENAGARISHVILI-F18S2G2

3 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 194