はじめに

This guide will show you how to replace the button panel on the Anker Souncore Motion Boom Plus device. The button panel allows you to operate the speaker manual; this is where you can use the power, Bluetooth, and volume buttons. If any buttons are unresponsive, the device's button panel may need to be replaced.

Power off the device before continuing to tear it down. Ensure that you use the proper tools to prevent damage to any components on the device.

必要な工具と部品

手順1 Case

Anker Soundcore Motion Boom Plus Button Panel Replacement, Case: 手順 1、 3の画像 1

Anker Soundcore Motion Boom Plus Button Panel Replacement, Case: 手順 1、 3の画像 2

Anker Soundcore Motion Boom Plus Button Panel Replacement, Case: 手順 1、 3の画像 3

Insert an opening tool into the seam between the speaker grille and the chassis.
Pry the tool around the top, bottom, and sides until the grille fully releases.
Apply gentle pressure to avoid damaging the grille.
Remove the grille.

翻訳

手順2

Remove the two passive radiators on either side of the device.
Avoid pulling too hard or with too much force to prevent breaking the passive radiators.

翻訳

手順3

Remove the sixteen 14 mm Phillips screws, eight on each end of the speaker.

翻訳

手順4

Anker Soundcore Motion Boom Plus Button Panel Replacement: 手順 4、 3の画像 3

Gently remove the handle from the device by clicking off the handles from the sides and then pulling it off.

翻訳

手順5

Flip the speaker onto its side and use a spudger to remove the two rubber feet on the bottom of the device.

翻訳

手順6

Remove the eleven 13 mm Philips screws that secure the driver housing.

翻訳

手順7

Remove the two 14 mm Phillips screws located on each side of the handle, near the clip points.

翻訳

手順8

Remove the four 14 mm Philips screws on the top of the device.

翻訳

手順9

Insert a spudger into the seam on top of the device.
Gently pry the casing open.

翻訳

手順10

Anker Soundcore Motion Boom Plus Button Panel Replacement: 手順 10、 3の画像 3

Disconnect each of the three cables by gently pulling the connectors out of their sockets.
Do not pull with force. The ribbon cables are fragile and easily break.

翻訳

手順11 Button Panel

Anker Soundcore Motion Boom Plus Button Panel Replacement, Button Panel: 手順 11、 2の画像 1

Anker Soundcore Motion Boom Plus Button Panel Replacement, Button Panel: 手順 11、 2の画像 2

Remove all eight 7 mm Phillips screws securing the button panel to the top of the case.

翻訳

手順12

Remove the button panel.

翻訳

終わりに

To reassemble your device, follow the above steps in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.