Skip to main content

ガイド紹介

If you need to replace your hard drive because it is broken or in need of upgrading, this is the guide for you! In order to go ahead with this guide, you must have already taken the keyboard module off of the laptop. Please visit the prerequisite guide for more details.

パーツ

パーツは指定されていません。

  1. Use the Philips #1 Screwdriver to remove the 9 screws that hold the keyboard cover in place. Use the Philips #1 Screwdriver to remove the 9 screws that hold the keyboard cover in place.
    • Use the Philips #1 Screwdriver to remove the 9 screws that hold the keyboard cover in place.

  2. Insert the flat edge of the spudger into the crease of the keyboard cover.
    • Insert the flat edge of the spudger into the crease of the keyboard cover.

    • While the spudger is in the crease, carefully pry open the casing by sliding the spudger along the edge.

    • Do not use excessive force to pry open the lid. You should hear each plastic clip snap open as you run the spudger along the edge.

  3. Make sure that the entire cover has been released from the plastic pins. Slowly lift the cover open from the front of the laptop, but do not completely remove.
    • Make sure that the entire cover has been released from the plastic pins.

    • Slowly lift the cover open from the front of the laptop, but do not completely remove.

    • Note the locations of the 3 white and blue data cables connecting to the keyboard to the computer's main board.

  4. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  5. Remove each data cable from the motherboard by using your finger or the black spudger to lift the black latch.
    • Remove each data cable from the motherboard by using your finger or the black spudger to lift the black latch.

    • The cable will slide out of its place.

  6. With the data cables removed and the keyboard module fully disconnected, the keyboard module should come free from the laptop.
    • With the data cables removed and the keyboard module fully disconnected, the keyboard module should come free from the laptop.

  7. Remove the four screws that hold the hard drive in place with the Philips #1 screwdriver. There are two screws connected to the motherboard and two screws connected directly to the case.
    • Remove the four screws that hold the hard drive in place with the Philips #1 screwdriver.

    • There are two screws connected to the motherboard and two screws connected directly to the case.

  8. Remove the hard drive by sliding it to the right to disconnect it from the motherboard and lifting out.
    • Remove the hard drive by sliding it to the right to disconnect it from the motherboard and lifting out.

    • Be sure to fully disconnect the hard drive from the motherboard to ensure that you do not damage the connectors.

    • If necessary, unscrew the old hard drive from the holster and screw the new one into the holster.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Richard Johnson

メンバー登録日: 2015年09月16日

662 Reputation

5のガイドは作成済み

チーム

IUPUI, Team 1-2, Baechle Fall 2015 IUPUI, Team 1-2, Baechle Fall 2015人のメンバー

IUPUI-BAECHLE-F15S1G2

3 メンバー

8のガイドは作成済み

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 12

All Time: 1,270