修理を始めるには コミュニティ ストア

2.2 GHz (Turbo Boost up to 3.4 GHz) もしくは2.5 GHz (Turbo Boost up to 3.7 GHz) quad-core Intel Core i7 processor with 6MB shared L3 cache.

467回答 すべてを表示

オプション

MacBook only start with external monitor and closed lid

Hello community,

i have a problem with a 15” MacBook Pro Mid 2014. I can only boot the macbook when a external monitor is connected and the lid is closed. If I try to start the macbook without a external monitor I hear the macbook chime, but only the backlight is working and nothing appears on the screen.

I also tried to open the lid after I booted the device with the external monitor. But as soon as I open the lid the MacBook freezes.

Maybe someone give me a tip to find a solution.

Thank you.

Update

Here are the photos from the display connector and cable. In my opinion they look good.

Block Image

Block Image

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Sounds like your internal display or its cable is damaged. Take the bottom cover off and inspect the display cables connection on the right side do you see any corrosion or physical damage?

Block Image

Heres the IFIXIT guide to pull the bottom cover off MacBook Pro 15インチ Retinaディスプレイ Mid 2014 底ケースの交換

Update (12/04/2018)

@blob810 - Did you check the display cable connection? I’ve seen a few with corrosion which shorted out the data lines which then causes the system to freeze up. After disconnecting the battery disconnect the cable and then re-power the logic board with an external display does opening the lid mess up the display?

If it does then @benjamen50 is correct your Hall Sensor logic is messed up. The location of the sensor is located on the backside of the logic board.

Block Image

You’ll need to check for corrosion damage on that side of the logic board once you take it out MacBook Pro 15インチ Retina Display Mid 2014のロジックボードの交換

MacBook Pro 15" Retina Display Mid 2014 底ケースの画像

ガイド

MacBook Pro 15インチ Retinaディスプレイ Mid 2014 底ケースの交換

難易度：

中レベル

—

5 - 10 minutes
MacBook Pro 15" Retina Display Mid 2014 ロジックボードの画像

ガイド

MacBook Pro 15インチ Retina Display Mid 2014のロジックボードの交換

難易度：

中レベル

—

30 minutes - 2 hours

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

6 件のコメント:

I already tried it. The cable and the connector looks fine. I wonder if its a problem with the display or with the logic board. Because the macbook only starts with the closed lid or disconnected display cable, otherwise the device freeze while booting.

さんによる

Most likely the logic board has been liquid damaged. It sounds like the hall effect sensor circuit needs diagnosing.

That circuit is responsible for sensing whether or not the MacBook is closed or open via magnetic sensors. It controls the display and backlight enable circuits as well.

To do that it requires microsoldering rework / circuit diagnosing on the logic board.

You may be able to find a reputable repair shop that repairs liquid damaged MacBook to fix this problem for you.

さんによる

Hello Ben,

thanks for your answer. I have a SMD soldering station here and a FLUKE multimeter. Where is the Hall effect sensor and his circuit located on this device. Maybe someone can instruct me which pins and components I should measure.

さんによる

When I fire up the macbook with disconnected internal monitor and connected external monitor, I can open and close the lid without messed up the external monitor. So I think the Hall effect sensor is good. I've tested this scenario yesterday. Question: Can I test a the display assembly on a 13" MacBook Pro from the same year, also mid 2014. Only to be sure that not the display or the internal cable is broken.

さんによる

@blob810 - inspection is the only real way to figure this out take a good detailed image of the logic board connector and the cable end so I can see how it looks iFixitでの質問に画像を追加する方法

さんによる

1以上のコメントを表示

コメントを追加

回答を追加する

blob810 さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 555