評価: 21
1
1
Hi I can’t seem to find the right answer I am trying to restore an old 6s but each time I do it’s like almost done it says “error -1 or 4013 . Or it says phone could not be found I tried 3 computers and different cords and different usb spots need any help
この質問は役に立ちましたか？
評価: 159.7千
11
191
368
If I remember correctly the fix for this is to remove the baseband chip and make jumpers for certain pads. Then the chip would need to be reballed by a stencil and put back onto the logic board.
4013 can sometimes be the NAND needing reprogramming and/or replacement using ipbox or naviplus pro 300.
-1 is for baseband like I said above.
Both of these fixes require microsoldering.
このアンサーは役に立ちましたか？
Yes! I contacted eBay sellers and found it out
過去 24時間: 0
過去 7 日: 0
過去 30 日: 1
今までの合計 1,175
